about us

products

projects

faqs

media

contact us

home

 



 

 

 

 



 

 

610V Hybrid Aeroturbine

The 610V Hybrid Aeroturbine consists of twin helical rotors and airfoils housed within two 6 ft. x 10 ft. steel cages combined with a shelf of 12 photovoltaic solar panels. The full system weighs approximately 1400 lbs. including the alternators, without ballast.  The standard 610V2 Hybrid Aeroturbine is 20 ft. tall and the solar shelf spans 31 ft. The typical power rating for each of the 12 solar panels is 175 Watts for a total of 2100 Watts. The 610V2 Hybrid is intended for vertical mounting and can be either bolted or ballasted down.  Vertical Aeroturbines work well in winds from any direction, and therefore the presence of a dominant wind direction is not critical.  The 610V2 Hybrid is modular and may be horizontally extended indefinately to create very large wind and solar electric arrays covering entire urban rooftops.

 

All Aeroturbines are designed and custom-built to fit the architecture of the building. Exact costs will depend on project location, number of turbines purchased, and the required mounting method.  The 610V2 Hybrid Aeroturbine has an estimated cost of $60,000.  This price includes the rotors, cages, mounting structures, 12 - 175 Watt photovoltaic solar panels, the support structure for the solar, and all the electronic equipment.  The installed cost of Aeroturbines will dramatically decrease when manufacturing begins. The more turbines you order the less they will cost.

In order to operate efficiently, Aeroturbines must be installed in at least 10 mph per year average wind speeds. In this average, with the 2,000 Watts of solar, each 610V2 Hybrid can produce 10,000 watts annually (solar and wind estimated total annually is 12,000 Watts). The 610V2 Hybrid needs to be building attached, and above or away from surrounding trees and other obstructions.

Aeroturbines are available for limited multifamily residential buildings, institutional buildings and commercial buildings in the Chicago area and on a very limited basis everywhere else.

We currently do not have an extensive dealer network in place. Manufacturing will need to increase before more dealerships can open. You would need a dealer in your area to take delivery of the Aeroturbines, do the installation, and maintain them for you properly. We currently have dealers located in Chicago, Illinois and Oconomowoc, Wisconsin. Only projects 50 miles of these dealerships will be considered at this time.

Power Specifications

Aerotecture Warranty
Certification Letter